+

the red have an orange deck

a bit of taping

well, here taping a couple of board prior to paint them
up: taping to airbrush the deck and 70% of the rails

down: the other board taping is to airbrush the bottom and rails
after dry, taping again to airbrush the deck with other colour (not showed).

shape lines

this photo was taked with a real camera, not a digi one...
hope you like it

fresh

...this week boards

egg

egg 7´4´´ x 22´´ (Wide point in the middle) x 2 3/4´´
sporting
modern continuous rocker; flat bottom; flat deck; 60/40 s full rails to hard boxy ones on tail (due to that I put 3 fins); "speed finish"; 2 4 oz Aerialite on top, 1 in the bottom

not surf related

well, this week has let me somewhat disappointed...

cause I should have started a 4 years technical degree: Systems Analyst; but didn t ...

the stupid institute dont start cause they say that dont have enough admissions
and its an expensive degree.

so I must wait up till next year...
but who knows what I m doing next year...motherfuckers
I tell you, its all about the money, not the admissions

I wish the State University had this degree; so it would start nevermind the money

set up

board is 6´7´´ miniegg (teardrop)

the rear fin is not too forward like it looks in the top photo (damn stupid digi cams)
well, I put this fin set up (2 stabilizers and a more vertical rear one) for a rider who stand up very forward and also want a looser board (it have no "v" bottom)
the rear fin is a bit larger and vertical than a "normal" one, but not flexible
have the rake "forced" back to maintain a bit of hold.