logotype

being placed under the sheet of fiberglass
normally I put this one on the bottom

for the non surfers: is not a "car type" decal. I mean, they have no glue, and is not a "plastic or vinilic". its just a thin paper who transparent when glued with resin
they have water tints to avoid resin bleeding problems

dynamics...sort of

I ve found this sketch about some "tunnel" fins that I did several years ago...
a bit silly

color work

P. S.: ...in the photo do not appreciate well the details

yeaahh!

...back again in the water after 110 days out!
I dont know if Im totally recover, but I dont have any pain.

well, the surf was very good (4´ real), the day very nice but very crowded...

I surfed in the same pointbreak that I d hit dee rock.

my skill isnt good...Im disappointed, cause I had been taking good waves but after the bottom turn, when I go to hit the lip..I cant turn! (in the lip) very well, so I wasted the wave..

anyway I think that my surfing skill with the time will improve..in this year I cant surfing the times that I wanted...too much work, and these 110 days out too.

cheers
and thanks everyone that showed interest in my recovery

"vent" channels

white one

6´2´´x 19 1/2´´(W.P. 2.5 down the M) x 2 3/8´´. Thruster. Bottom: flat, concave, double conc. between side fins, flat behind rear fin.
60/40 full rails
slightly domed deck
notice the logotypes: normally I put the M back and the signature logo on top.
notice also the smaller rear fin and the thin shape of the fins. Due to the flat faced waves and back foot rider style.
you se also the last 1/3 rail (volume, shape, tucked edge, hard ones on tail)

++the photos dont have enough light; due to the day and the chip cámera...so they re kind of out focus..